Dp301.013 to flash

[jingleguy]

This is what I got, I could not figure out how to use speed 2 for NT

USB JTAG NT 0.30
Latest version is 0.31
-detect
IDCODE 1D405041
STi STi5518
Found Address= 7fc00000 ST 29W320DT
-ldram firm
-erase firm
Erase starts...
Erase time 00:00:51 (.118)
-cmpram firm
Compare data Failed address 7FC00000,target FF,PC memory 03
-erase firm
Erase starts...
Erase time 00:00:51 (.569)
-cmpram firm
Compare data Failed address 7FC00000,target FF,PC memory 03
-sprogram firm
Program Starts...

[CAPONE]

If it stops at 50%. Check if the second flash is bad for TWO chip box.

Most of the 301.013's are single TSOP that need the VID MOD. Very seldom do the 2 TSOP 301.013's need a VID MOD.

[CAPONE]

I have a usbjtagnt and a buffered jtag which has alligator clip and 6 pongo pins. When I used the usbjtagnt, I jtag the ird from the top, R79 is grounded on the bottom. Software detect the Ird right away and erase the flash in 50 sec. When it start writing, it write about 25% then stop 4 min then start writing and go to 50% and stay there. I didn't turn on the vidmod since there is no 100% flash in the ird. I will try grounding Pins 18-25 and turn on the vidmod. This weekend will be it's last day in this earth then it will be smelling my trash in trashcan . Or I will use it for parts..

Same thing with the Buffered Jtag.. I jtag it from the bottom and R79 is gounded, alligator clip is connected to the metal of the IRD. Erase good, then it program only 50% and it gives me an error with the flash.

It's a single chip and I have program it before with the buffered jtag with 4mb flash..Can I play with the 301.013 dll files in the USBJTAGNT?

If you intend to full erase and program TSOP then you must turn on VID MOD. So people say they turn it on @ 99% DON'T know why LOL I have always turned it on before I start to erase then program and never had a Problem.

You never did answer what is getting extramly hot. The CPU? ( Big Square Chip ) Or the TSOP?