dreambox 100 jtag ? is it possible to do this >?

saj070 · Post by **saj070** » Tue Feb 09, 2010 8:15 pm

I have a european dm100 and would like to install a usa version firmware on dm100 both receiver are the same only different is one has a european firmware and the other is USa

all i want to do is extract the usa and load into european using usbjtag NT with the nt software program ?

it has 10 pin header slots and same chip see attach pics and data sheet

you can download the pictures and data sheet from link below

http://www.megaupload.com/?d=HNLEF0NA

Post by **usbbdm** » Wed Feb 10, 2010 12:50 am

The datasheet for the flash is not important. What is the CPU? If it is MIPS it is very likely it can be supported easily. If it is ARM based it is not support yet.

saj070 · Post by **saj070** » Wed Feb 10, 2010 5:28 pm

usbbdm wrote:The datasheet for the flash is not important. What is the CPU? If it is MIPS it is very likely it can be supported easily. If it is ARM based it is not support yet.

how can i find out what is the CPU ??

thanks for replying

saj070 · Post by **saj070** » Fri Feb 12, 2010 2:21 pm

usbbdm wrote:The datasheet for the flash is not important. What is the CPU? If it is MIPS it is very likely it can be supported easily. If it is ARM based it is not support yet.

let me know how i can retreat this information ??

thanks

Post by **usbbdm** » Fri Feb 12, 2010 3:54 pm

Check your PM.

saj070 · Post by **saj070** » Sat Feb 27, 2010 11:17 am

usbbdm wrote:Check your PM.

sorry i was on vacation i sent you a pm with piccs

USB JTAG

dreambox 100 jtag ? is it possible to do this >?

dreambox 100 jtag ? is it possible to do this >?

Who is online