Chips all warm by comparing to working 700.
-detect IDCODE 41C5501D
Motorola 17500QK
IMPCODE 40404000
EJTAG V1, V2.0
DMA not supoorted
( blank )
un-plugged & re-plugged-tap c
Eco :00000000
-tap a FFFFFFFF
Eco :00001000
-tap c
Eco :00000000
-tap a FFFFFFFF
Eco :80000000
Would this still imply "bad connection"?
Plugged Again
-tap c
Eco :00000000
-tap a FFFFFFFF
Eco :80400000
Plugged usb into working 700
Did Detect - ok
Then switched to non-working box
Speed 2
Loaded Boot
Sprogram Boot
It Ran
But write did not stick
No lights anytime and can not read memory.
bk - cannot read registers (blank)
Please read above if it has been tried.
As a last resort can I use the 3.3v jumper to the #2 pin (TSOP) on the DCT700 or should be replaced?