hello all, any1 have any new info on a sb4220? i see it has a 14 pin connector. i have succesfully used a rs-232 serieal cale. here is a copy of the console dump. but i have had no luck jtagging this thing.
Power-On
Cable Modem Image starter
Texas Instruments (C) 2002
Version 02.00
Flash autodetection returned: 0x00000000
VendorID: 0x0089 DeviceID: 0x88C2
Select image to run: [1][2]
Running image #1.
Trying to run Default Image
Prefix address - B0010000 Found image CRC OK; Decompressing
..................................
Well, looks OK; Let's go
Target Name: vxTarget
Attached TCP/IP interface to emac unit 0
NFS client support not included.
0x947ffdf0 (tRootTask): Loading RNDIS End Driver...
0x947ffdf0 (tRootTask): Memory setup complete
0x947ffdf0 (tRootTask): Configuring rndis2...
0x947ffdf0 (tRootTask): Done loading RNDIS END.
SB4220: MIPS Core speed is 125.00 MHz (100 Ticks per second)
Installed MIPS exception handler
Initialized BBIF
****
****
******o***
********_///_****
******/_//_/*****
** ***(__|*****
*********
****
***
***********************************
** Texas Instruments ***
** DOCSIS based Cable Modem ***
***********************************
Version 6.3.3 (Build 20_08_02:1) - Creation Date/Time: Nov 26 2002 / 09:45:01
Initializing FLASH driver returned 0
USB_Init
0x947ffdf0 (tRootTask): After USB_Init
CONSOLE-CLI was disabled at compile-time.
InitCB
init RNDIS CB
Attaching network interface lo0... done.
?sb4220?
Who is online
Users browsing this forum: No registered users and 3 guests