i have tried to change the firmware but for some reason you change it do a cmpram averything goes ok but the firmware stays the same 0.1.9.3 im using the sbg900 tabs and i program the firmware in the app tab another thing is that i havent been able to do program y have to use erase app and then sprogram app.
the cpu its a broadcom 3360 and the flash is an Intel 28F640J3 i had to add the cpu to the vendors list to get it working.
Sbg1000 help
-
- Junior Member
- Posts: 122
- Joined: Mon Feb 05, 2007 7:33 pm
- Contact:
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
There might be two copies of the firmware and you only change one of them.nunny wrote:i have tried to change the firmware but for some reason you change it do a cmpram averything goes ok but the firmware stays the same 0.1.9.3 im using the sbg900 tabs and i program the firmware in the app tab another thing is that i havent been able to do program y have to use erase app and then sprogram app.
the cpu its a broadcom 3360 and the flash is an Intel 28F640J3 i had to add the cpu to the vendors list to get it working.
-
- Junior Member
- Posts: 122
- Joined: Mon Feb 05, 2007 7:33 pm
- Contact:
i have cheked the Intel 28F640J3 and i think its 4MB did a 4mb backup and i only see one copy of the firmware using a hex editor.
i have some firmwares here and they are 3.15MB the las one that i tried is a .p7 what i did was remove the header to make it a bin flashed it to the modem and still the same it didnt change
i have some firmwares here and they are 3.15MB the las one that i tried is a .p7 what i did was remove the header to make it a bin flashed it to the modem and still the same it didnt change
-
- Junior Member
- Posts: 7
- Joined: Fri Jan 26, 2007 5:41 pm
- Location: JERSEY
i'm trying to flash this modem with haxoware 1.1 rev31 since i dont care about the wifi on this modem but i'm getting this error:
Dest must start at the boundary of a block
i can detect the modem and backup original firmware this modem should work with haxoware 1.1 rev31. because it's like a webstar dcp2100r2 with the spantion flash.
IDCODE 0334917F
Broadcom BCM3349
IMPCODE 800904
DMA supoorted
Found Address= 9fc00000 Intel 28F640J3
Dest must start at the boundary of a block
i can detect the modem and backup original firmware this modem should work with haxoware 1.1 rev31. because it's like a webstar dcp2100r2 with the spantion flash.
IDCODE 0334917F
Broadcom BCM3349
IMPCODE 800904
DMA supoorted
Found Address= 9fc00000 Intel 28F640J3
Who is online
Users browsing this forum: No registered users and 1 guest