sbg900 unable to flash.
-
- Junior Member
- Posts: 32
- Joined: Fri Feb 05, 2010 2:16 pm
sbg900 unable to flash.
Well I'm trying to flash a SBG900 but I only see that it is erasing but nothing happens, after waiting 2 hours I just stop the process, I'm using UJmodem after many attempts I'm sure I bricked it, the software still recognize the flash but the problem persists, I found the boot-loader and all the other parts but still I see that it says erasing but nothing happens It only says erasing and the status bar will never move, well this is my first time with a sbg900 If somebody has a full dump with the telnet open to try or an advice to make it work I will appreciate, thank you.
-
- Junior Member
- Posts: 32
- Joined: Fri Feb 05, 2010 2:16 pm
well this are the steps I'm following.
Detect
Tap c
tap a ffffffff
then locks to debug on
then I erase the whole flash
then:
poke 9fc00000
then I see I see Data=0XFFFFFFFF at the end of the output if not I Erase the whole flash again until I see it.
then If I do the erase command doesn't work but if I do it in the tab it does work (maybe a bug in the software)
then
-sprogram Boot it starts programing but gets stuck about 25%
any Ideas ?????
Also I notice when I choose sbg900 it shows sgb900 on top of the windows
Detect
Tap c
tap a ffffffff
then locks to debug on
then I erase the whole flash
then:
poke 9fc00000
then I see I see Data=0XFFFFFFFF at the end of the output if not I Erase the whole flash again until I see it.
then If I do the erase command doesn't work but if I do it in the tab it does work (maybe a bug in the software)
then
-sprogram Boot it starts programing but gets stuck about 25%
any Ideas ?????
Also I notice when I choose sbg900 it shows sgb900 on top of the windows
Who is online
Users browsing this forum: No registered users and 1 guest