Wondering what tools/methods you guys have successfully used to unpack firmware from DCT devices? I say all devices because I would like to look at whatever devices I can.
On a side note, and I hope it doesn't throw off my original question but has anyone been able to successfully read an XC and create an assembler dump from it? I have looked around the forum, though I haven't found any raw assembler dumps from those who have claimed to of read it. I would be interested if anyone who has done it, could provide one.
Unpacking DCTXXX(X) firmware?
Moderator: justsomeguy
-
- Junior Member
- Posts: 246
- Joined: Thu Jun 28, 2007 8:49 pm
aint no true testers around here anymore..99.9% dont even know what you are asking.
i unpacked ocap firmware a while ago using binwalk and dd. just the jff filesystem though, not the boot.
unfortunately usbbdm is not interested anymore either. i seem to recall he could not decompress firmware from HD boxes..he could not figure out the algo.
i unpacked ocap firmware a while ago using binwalk and dd. just the jff filesystem though, not the boot.
unfortunately usbbdm is not interested anymore either. i seem to recall he could not decompress firmware from HD boxes..he could not figure out the algo.
-
- Junior Member
- Posts: 246
- Joined: Thu Jun 28, 2007 8:49 pm
Who is online
Users browsing this forum: No registered users and 6 guests