i have a porblem with usbjtag and epr2320 modem..
im runninng las version of usnjtag
when i ocnnect the modem to usbjtag the program recognizas it like a bcm3349 but fisically has a bcm 3348
the mode to flash it is sbg900 because qhen i put in other mode the advertise to select a correbt configuration
when i start ti flash with a backup the modem go dead because when is writing is writing worse (i am usin sprogram and i have the same problem)
epr2320 bcm3348
-
- Junior Member
- Posts: 8962
- Joined: Mon Jul 18, 2005 9:33 pm
Are you sure that CPU detection is not right?
What the CPU ID says?
Can you put the result of detect?
Please wait for 0.20 out to fix things like program failure. You must be legal user to use 0.20 since activation is needed. There are too many things to do now and I have too many device to test to debrick. Maybe I can only test part of them for 0.20 and 0.21 will soon come after that with rest of the device debrick tested.
What the CPU ID says?
Can you put the result of detect?
Please wait for 0.20 out to fix things like program failure. You must be legal user to use 0.20 since activation is needed. There are too many things to do now and I have too many device to test to debrick. Maybe I can only test part of them for 0.20 and 0.21 will soon come after that with rest of the device debrick tested.
-
- Junior Member
- Posts: 10
- Joined: Fri Nov 30, 2007 1:33 am
-
- Junior Member
- Posts: 8962
- Joined: Mon Jul 18, 2005 9:33 pm
sprogram has a bug found during debrick WRT54GS. There is no work around yes and need to wait 0.20 to fix it. This is especially true for Intel chip. Virtually the block unlock command needs to issued for each block brefore do sprogram. The old program do programming without unlock the block and thus failed. It does not happen on most of the devices I have tested. For DMA supported device, the debrick process should work better.
Who is online
Users browsing this forum: No registered users and 9 guests