4dtv receiver

XC chip, auth and block SPI command.
Locked
feedmaster
Junior Member
Posts: 9
Joined: Fri Feb 03, 2012 11:42 am

4dtv receiver

Post by feedmaster »

Is there any program to interface with these receivers?
usbbdm
Junior Member
Posts: 8713
Joined: Mon Jul 18, 2005 9:33 pm

Post by usbbdm »

I think this is using BDM not JTAG.
feedmaster
Junior Member
Posts: 9
Joined: Fri Feb 03, 2012 11:42 am

Post by feedmaster »

ya it says something about bdm. I thought they went hand in hand.
CAPONE
Junior Member
Posts: 5014
Joined: Sat Dec 27, 2008 3:25 pm

Post by CAPONE »

feedmaster wrote:ya it says something about bdm. I thought they went hand in hand.
USBBDM and USBJTAG NT Share they same Software. Its been that way for a Long Time. There was a time it had a Separate Software but Not any More. Now The Software will Know whitch to Use Depending on the Target you wish To Program.

Clearly what You Need to Do IS READ Buddy. So you can Understand How the Software Works. 90% Of the Main INFO You NEED Is Located on the Links to the Left Side of your SCREEN.....
feedmaster
Junior Member
Posts: 9
Joined: Fri Feb 03, 2012 11:42 am

Post by feedmaster »

Where is the best place to start for a beginner?
CAPONE
Junior Member
Posts: 5014
Joined: Sat Dec 27, 2008 3:25 pm

Post by CAPONE »

feedmaster wrote:Where is the best place to start for a beginner?
Left side of your Screen As I Indicated. You can allways Use the Search Tab to Find Posts on the target you wish to Program....
bdm
Junior Member
Posts: 36
Joined: Wed Mar 10, 2010 2:09 pm

Azbox bravo hd

Post by bdm »

Hola hay un problema con este receptor satelital
cuando tienen un golpe de corriente se muere el micro y queda en power on y no se puede recuperar .. Lee podras leerlo con el usbjtag nt ?
bdm
Junior Member
Posts: 36
Joined: Wed Mar 10, 2010 2:09 pm

Azbox bravo hd

Post by bdm »

Hello lee. We have a problem, there is a hd receiver azbox bravo. When you have a current voltage of stops working the micro
power and is on display. You can read the usbjtagnt
bdm
Junior Member
Posts: 36
Joined: Wed Mar 10, 2010 2:09 pm

Azbox bravo hd

Post by bdm »

usbbdm wrote:i think this is using bdm not jtag.

hello lee. We have a problem, there is a hd receiver azbox bravo. When you have a current voltage of stops working the micro
power and is on display. You can read the usbjtagnt
Locked

Who is online

Users browsing this forum: No registered users and 1 guest