I am having a rough time.I have an non ph board.with firmware 5.50.I can't seem to load the conected firmware on this board.
Right now I am at a point that I can get the guide and firmware updated,but no(video)one moment please message,or I have to go with old firmware and no guide (with video).
I would like to get video and guide at same time.
The nvram I am using works fine on my other board.
Any Ideas?Any and all help is greatly appreciated.
Non PH Board problem.
-
- Junior Member
- Posts: 9
- Joined: Fri May 14, 2010 12:40 am
One moment please message display
I have an non-ph Old board type 1 with firmware 8.16, I can get guide with all channels and "one moment please" message displayed. I need help to get Video and Sounds. Any helps are greatly appreciated.
-
- Junior Member
- Posts: 54
- Joined: Fri Jul 17, 2009 12:21 pm
How did you get the guide and firmware updated? Also, change your eemid on your nvram from 01 01 to 03 01 before you load it to your box. That might help you to keep your guide.Zbigg wrote:I am having a rough time.I have an non ph board.with firmware 5.50.I can't seem to load the conected firmware on this board.
Right now I am at a point that I can get the guide and firmware updated,but no(video)one moment please message,or I have to go with old firmware and no guide (with video).
I would like to get video and guide at same time.
The nvram I am using works fine on my other board.
Any Ideas?Any and all help is greatly appreciated.
Thanks
-
- Junior Member
- Posts: 9
- Joined: Fri May 14, 2010 12:40 am
Non Ph board Type ?
I have a DCT 2244/1161 Non Ph old board. So I tried to find out which type it is? It had old firmware 5.34 and it is detected as Type 2. I hooked it up and it is updated to firmware 8.16 and now it is detected as Type 1. Any ideas?
-
- Junior Member
- Posts: 8981
- Joined: Mon Jul 18, 2005 9:33 pm
Check the memory of segment of 0x400000 if it is the start of firmware then it is type I. That is all you need to know if you need to swap the firmware or not.simplyvespa wrote:I have a DCT 2244/1161 Non Ph old board. So I tried to find out which type it is? It had old firmware 5.34 and it is detected as Type 2. I hooked it up and it is updated to firmware 8.16 and now it is detected as Type 1. Any ideas?
-
- Junior Member
- Posts: 9
- Joined: Fri May 14, 2010 12:40 am
-
- Junior Member
- Posts: 177
- Joined: Thu Jul 26, 2007 7:52 am
non ph
No. Different tuner. software for tuner is in nvram. need same nvram from box with same tuner.
Who is online
Users browsing this forum: No registered users and 5 guests