Tryng to connect to 10 pin in dct2224 with power of in box laptop and dct2244 and when turn on the DCT unit will not turn on but if USB BDM is disconnected the DCT will Turn on, this is first time using new USB BDM please any one help Newbie on first time i have a picture of location at10 pin close to power supply connector,is this the 10 pin for theUSB BDM ?
I will try to uploud the picture
Very thanks
DCT2224 10 Pin ?
-
- Junior Member
- Posts: 6
- Joined: Mon Jul 06, 2009 7:34 pm
DCT2224 10 Pin ?
You do not have the required permissions to view the files attached to this post.
-
- Junior Member
- Posts: 6
- Joined: Mon Jul 06, 2009 7:34 pm
dct2224 10 pin
USBBDM if you look at the picture the small paper is looking at pin #1 of the 10 pin the USB BDM was connected with the red mark at that pin
Note: This is a PH6 and C105 cap one side open
Note: This is a PH6 and C105 cap one side open
-
- Junior Member
- Posts: 8974
- Joined: Mon Jul 18, 2005 9:33 pm
-
- Junior Member
- Posts: 6
- Joined: Mon Jul 06, 2009 7:34 pm
DCT2224 10 Pin ?
Sorry USBDM the problem at this moment is software activation at the top of software display no activaved, sent e-mail asking for activation, them i will check again, thanks
Note: This software is .28 version
Note: This software is .28 version
Who is online
Users browsing this forum: No registered users and 7 guests