Ok so I have tried to put on 0793tvr7304rSPI.bin file in order to activate my box. Here are the following commands that I have used per VIDEO tutorial.
reset 1
init
ldram code of wich i pick the file 0793tvr7304rSPI
FLSHDCT code
it stops here. In video it shows that I should get some type of response
like
Found MX------
I did not get this reponse. What am I doing wrong here?
need help programing 2224
-
- Junior Member
- Posts: 31
- Joined: Thu Feb 12, 2009 6:12 pm
ok trying something differnt here also. From what I am gathering I have to change the address in my Reciver also to get it activated again? If so I tried to change it this way.
getram code
then go to drop down menu and pick address. I am not sure if I am supposed to change UNIT ADDRESS OR NETWORK or both? Also I have read that the reciver has 10 numbers for adress. Mine has 12 numbers under Unit address.
getram code
then go to drop down menu and pick address. I am not sure if I am supposed to change UNIT ADDRESS OR NETWORK or both? Also I have read that the reciver has 10 numbers for adress. Mine has 12 numbers under Unit address.
Who is online
Users browsing this forum: No registered users and 3 guests