Hi folks,
I'm trying to flash my DPC3000.
I followed the diagram that is found on this webpage: http://www.usbjtag.com/jtagnt/modem/dpc3000.php
As you can see in the photo below, the connection is perfect.
The wires inside the hooks are perfect. However when i try to detect it, I'm getting this error:
Unknown flash type!
Report these values http://www.usbjtag.com/vbforum ff,ff,ff
https://dl.dropboxusercontent.com/u/253 ... 000545.jpg
To verify if my USBJTAGNT is working properly, I successfully did a full backup of a dpc3825 and an sbg901.
I also tried different computers but the results are the same, and I use a USBTTL, nothing seems to be working with this DPC3000.
Has anyone had this issue?
DPC3000 NOT Detected
-
- Junior Member
- Posts: 93
- Joined: Fri Aug 01, 2008 6:14 pm
-
- Junior Member
- Posts: 93
- Joined: Fri Aug 01, 2008 6:14 pm
Ok, I might have solved it.
I was able to detect it.
Solution:
swap the ground for the spi and it will detect and flash without issues.
Pin 2(TRST) -----> ISP. Pin5 of U104
Pin 3(TDI) -----> Pin 15(SI)
Pin 5(TDO) -----> Pin 8(SO)
Pin 9(TCK) -----> Pin 16(SCK)
Pin 11(RESET) -----> Pin 7 (CS)
Pin 1(TRST) -----> Pin 10(GND)
CRAZY!!!!
I was able to flash the uff11 and ubf12 with forceware.
Also, I noted that ONLY one led remains on. I guess this has something to do with the firmware.
Thanks 4 reading
I was able to detect it.
Solution:
swap the ground for the spi and it will detect and flash without issues.
Pin 2(TRST) -----> ISP. Pin5 of U104
Pin 3(TDI) -----> Pin 15(SI)
Pin 5(TDO) -----> Pin 8(SO)
Pin 9(TCK) -----> Pin 16(SCK)
Pin 11(RESET) -----> Pin 7 (CS)
Pin 1(TRST) -----> Pin 10(GND)
CRAZY!!!!
I was able to flash the uff11 and ubf12 with forceware.
Also, I noted that ONLY one led remains on. I guess this has something to do with the firmware.
Thanks 4 reading
-
- Junior Member
- Posts: 53
- Joined: Thu Mar 18, 2010 5:47 pm
Who is online
Users browsing this forum: No registered users and 8 guests