Netgear R6350
-
- Junior Member
- Posts: 1
- Joined: Tue Jun 01, 2021 2:05 pm
Netgear R6350
I have a Netgear R6350 with a MX30LF1G18AC-TI NAND TSOP-48. How Can I use the u-Link NAND to flash it since it won't boot from a upgrade i did? I'm not sure on what to change in what files to get it to recognize the chip and be able to flash either the stock or OPENWRT bin files.
-
- Junior Member
- Posts: 1
- Joined: Tue Jun 01, 2021 2:05 pm
Re: Netgear R6350
Currently I get this ......
Those are the values I get consistently and I'm not sure also if I can flash the whole file or if I need a different one to flash.
Code: Select all
-flshdct 0
Unknown flash type!
Report these values http://www.usbjtag.com/phpbb3 c2h,f1h,80h,95h
-
- Junior Member
- Posts: 8978
- Joined: Mon Jul 18, 2005 9:33 pm
Re: Netgear R6350
Looks like you just need to get the flash defined in nandflash.xml
-
- Junior Member
- Posts: 1
- Joined: Tue Jun 01, 2021 2:05 pm
Re: Netgear R6350
I did and it doesn't complete the flash properly for some reason.
-
- Junior Member
- Posts: 1
- Joined: Tue Jun 01, 2021 2:05 pm
Re: Netgear R6350
All I have to do is select all flash and put the image there?
-
- Junior Member
- Posts: 8978
- Joined: Mon Jul 18, 2005 9:33 pm
Re: Netgear R6350
https://www.macronix.com/Lists/Datashee ... 20v1.2.pdf
Page 32. The ID match the description.
Add these lines at the end of nandflash.xml
<flash>
<id1>0xc2</id1>
<id2>0xF1</id2>
<id3>0x80</id3>
<id4>0x95</id4>
<name>MX30LF1G18AC</name>
<size>0x8400000</size>
<pagesize>0x840</pagesize>
<protocol>11</protocol>
<block>
<secnum>1024</secnum>
<secsize>0x21000</secsize>
</block>
</flash>
Page 32. The ID match the description.
Add these lines at the end of nandflash.xml
<flash>
<id1>0xc2</id1>
<id2>0xF1</id2>
<id3>0x80</id3>
<id4>0x95</id4>
<name>MX30LF1G18AC</name>
<size>0x8400000</size>
<pagesize>0x840</pagesize>
<protocol>11</protocol>
<block>
<secnum>1024</secnum>
<secsize>0x21000</secsize>
</block>
</flash>
-
- Junior Member
- Posts: 1
- Joined: Tue Jun 01, 2021 2:05 pm
Re: Netgear R6350
Thanks I will try that out and see if it works.
Who is online
Users browsing this forum: No registered users and 4 guests