I have received some report that after 0.15 some box cannot program DCT700 properly and I had seen one of the unit with MT28W320.
If you use latest software with CFI support you need to turn it off as MT28W320 does not seems to provide right info and will cause some trouble.
To do so, start the app and type
Nothing wrong for the software. It is just this chip provide the incorrect information about the buffer write. I will continue investigate this issue. In the mean time if your box cannot boot up after the programming after 0.15. Do the following.
Code: Select all
cfi 0
detect
ldram boot
erase boot
sprogram boot
Then reboot the box and use normal programming speed to program the plat.