Well am glad to see that someone else have a interest in this baby will donate one to the boss for testing if he wants just say the word also I didn't try powering up pin 2 I was trying pin 1 all the time will test pin 2 and post the results later good testing guys.
Whammy45 wrote:Well am glad to see that someone else have a interest in this baby will donate one to the boss for testing if he wants just say the word also I didn't try powering up pin 2 I was trying pin 1 all the time will test pin 2 and post the results later good testing guys.
I am currently working on new STi 710x target. This is a huge job. I could take a look of this target if someone donate the device. This has to be done after the STi work unless it is easy and not take more than two days of work.
usbbdm wrote:I am currently working on new STi 710x target. This is a huge job. I could take a look of this target if someone donate the device. This has to be done after the STi work unless it is easy and not take more than two days of work.
will donate as many as you need with battery.
now I did connected the spi to pin 5 of the small chip next to the chip (don't know the name) that we connect the 5 others wire to it and the same thing that happens to the 6120 and 6220 happened to the 802 that all the light goes out but I only get
Copyright (C) 2010,2011,2012
USB JTAG NT 0.54
Target: TM502G
-detect
IDCODE 00000000
SB6120 and SB6220 Are essencialy the same thing Therefore there is No SB6220 Target in the software Only SB6120. DUH.
So My Point is, This is a DUMB Statement.
I tried everything, including 6120 and 6220 setting